Activity tab in model data under Activity Template header
The zone type can be set at block or zone level on the Activity tab and can be one of:
1-Standard - considered to be occupied and heated or cooled.
2-Semi-exterior unconditioned - is an unoccupied zone in the building which is neither heated or cooled. Examples of 'semi-exterior unconditioned' spaces are roofspaces, sunspaces, car parks etc).
3-Cavity - the zone is a cavity such as the glazed cavity within a double facade or a Trombe wall. This algorithm correctly calculates the convection coefficients for a narrow sealed vertical cavity based on the ISO 15099 standard.
4-Plenum - the zone is a plenum which is unoccupied and has no heating, cooling, or mechanical ventilation (though of course air will flow through it to meet the needs of the zones it serves).
When the Zone type is set to 2-Semi-exterior unconditioned, the program asks you 'Do you want to load default unoccupied data including Activity, HVAC and Construction templates'. If you reply 'Yes' then the zone is set as unoccupied by loading <None> Activity, HVAC and Lighting template data.
Also Semi-exposed constructions will be used instead of standard partitions for adjacencies with 'Semi-exterior unconditioned' zones. For example the wall between an occupied office and a car park would use the Semi-exposed construction, whereas the wall between two occupied offices would use Internal partition construction.
Also roofspace insulation is applied in the floor of a Semi-exterior unconditioned space when it is above a Standard space, if 'Floor fitted above floor slab' option is checked.
When the Zone type is set to 3-Cavity, the program asks you 'Do you want to load default 'Glazed cavity' data including appropriate convection coefficients, calculation options and Activity, HVAC and Construction templates'. If you reply 'Yes' then the following changes are made:
The zone is set as unoccupied by loading <None> Activity, HVAC and Lighting template data.
Suspended floors and ceilings are switched off.
The 5-Cavity Inside convection algorithm is set for Cooling design, Heating design and simulation calculations.
The 3-Full interior and exterior Solar distribution algorithm is set for Cooling design and simulation calculations.
You can find out more about Trombe wall simulations in the Modelling Issues section.
When the Zone type is set to 4-Plenum, the program asks you 'Do you want to load default plenum data including appropriate convection coefficients, calculation options and Activity and HVAC templates?'. If you reply 'Yes' then the following changes are made:
The zone is set as unoccupied by loading <None> Activity, HVAC and Lighting template data.
Suspended floors and ceilings are switched off.
The 4-Ceiling diffuser Inside convection algorithm is set for Cooling design, Heating design and simulation calculations.
You can find out more about modelling plenums under HVAC.